Your arc decides how big the rim looks to your ball. Shoot flat and your ball has to thread a narrow gap; shoot with a good arc and the same rim opens up. You can measure your arc with three numbers: the angle your ball leaves your hand, the height it reaches and the angle it drops into the rim.
See why a flat shot misses
An NBA rim measures 18 in across on the inside, per Rule 1 of the NBA rulebook, and a men's ball measures about 9.4 in across. Straight down, your ball has almost 9 in to spare.
Come in at an angle and the rim shrinks from your ball's point of view. The opening your ball sees equals 18 in times the sine of your entry angle:
| Entry angle | Opening your ball sees | Room left for a 9.4 in ball |
|---|---|---|
| 30° | 9.0 in | none: it must hit the rim |
| 35° | 10.3 in | 0.9 in |
| 40° | 11.6 in | 2.2 in |
| 45° | 12.7 in | 3.3 in |
| 50° | 13.8 in | 4.4 in |
Drop below about 32 degrees and even a perfect shot has to touch iron. That is why flat shooters live on the front rim.
Launch your shot at around 50 degrees
Your release angle sets your entry angle. Released below the rim, your ball always comes down a little flatter than it went up, so you launch steeper than the entry you want.
Engineers at North Carolina State ran hundreds of thousands of simulated free throws and found the best launch angle at 52 degrees for a shooter who lets the ball go 7 ft off the floor, with the aim toward the back of the rim and up to 3 revolutions a second of backspin. They also found you gain from releasing as high as you can, as long as your shot stays consistent.
Release higher on your jumper and you can go a touch flatter. Release low, from your chest, and you need more arc.
Drop it in at around 45 degrees
Steeper gives your ball more room, yet past 50 degrees you start fighting for distance control: a high moon ball needs more force and a small change in that force moves the ball a long way. Aim for an entry angle around 45 degrees. You keep about 3 in of room and a shot you can repeat.
Read your arc on video
You can estimate your angles from any clip shot from the side:
- Stand your phone square to the line between you and the rim, far enough back to see both your release and the rim.
- Step to the frame where the ball leaves your hand and the next two or three frames. The direction the ball travels gives your release angle.
- Step to the frames where the ball crosses the height of the rim. The direction it falls gives your entry angle.
Shoot 10 from one spot and look at the spread. A shooter whose release angles stay within a few degrees misses less than one who averages the right number with a wide spread.
Fix a flat shot
- Lift from the legs. A stiff dip forces your arms to push the ball out instead of up. Check your knee bend in how to fix your jump shot form.
- Set the ball higher. Bring it up over your shooting eye and release from there.
- Finish up. Hold your follow-through with your fingers pointing at the rim, as if you reach into a cookie jar on a high shelf.
Drill: over the ball. Picture a ball resting on the front of the rim. From 6 ft, shoot 20 shots that clear it, then step back to the free-throw line. Track your makes, then take the same arc to the free-throw line.
Match your arc to the shot
You shoot different arcs from different spots, and that is fine as long as each one stays consistent:
- Layups and floaters. Use the backboard on layups. On a floater over a big man, go higher: a steep entry clears the hand and still finds the rim.
- Mid-range jumpers. Your release sits high and the rim sits close, so a release around 50 degrees drops in steeply with little effort.
- Threes. The longer distance tempts you to flatten out and push. Stay with the same angle and let your legs add the distance. A flat three needs a perfect line and a perfect length.
- Free throws. No defender, the same spot every time: lock in your arc here first, then carry it to the rest of the floor.
Avoid the common arc mistakes
- Aiming at the front of the rim. You shorten your shot and your misses bounce off the front. Look at the back of the rim, as the NC State simulations suggest.
- Shooting a moon ball. Past 55 to 60 degrees you need much more force and lose control of distance. Keep it high and stop short of a moon ball.
- Changing your arc when you miss. A miss short is usually your legs. Fix your dip before you change your angle.
- Pushing from the chest. Players with weak legs push the ball out from the chest and shoot flat. Raise your set point and release up.
Measure every arc you shoot
Drawing angles on paused frames takes a while. Read your arcs with Hoopmaxxing. Shoot with the rim in view and tap the rim once: your replay draws every arc, counts your makes and reads your release angle, your arc height and your entry angle, shot by shot.
Want more lift under your shot? Check your takeoff with the vertical jump calculator.

